Send me a FREE trial issue Plus a FREE gift
Old-House Online » Old-House Tips, Restoration Stories, & More » Stuff Ectoplasm Screwed Up

Stuff Ectoplasm Screwed Up

"Our 165-year-old interior doors sometimes pop open without human help. Do we have a ghost?" —Kathy Stein

    (Illustration: Brett Affrunti)

    (Illustration: Brett Affrunti)

    “Our farmhouse was built around 1850. We love the old interior doors, which still have their original hardware. But sometimes they quietly swing open, with no one nearby. During the day, I find the idea of a ghost romantic. But not so much when I’m home alone at night.” —Kathy Stein

    Old doors fail to shut properly, or swing open and shut by themselves, for any number of reasons. Houses tend to settle over time, which can mean the doorways are no longer plumb and square.

    Check the hinge first. If the pins are not stacked directly above each other, they tend to bind and pop the door open. If so, remove the hinge and tighten it in a vise to bring it back into alignment. Or replace it with a similar salvaged or reproduction hinge.

    If the door is warped or out of square, don’t try to fix it. It’s better to trim the stop on the door jamb (the upright piece of the door frame) where it’s rubbing. Shave just a few millimeters at a time with a rabbet plane. Then adjust the position of the striker plate (mating hardware for the latch) until everything lines up—or the door stops popping open, whichever comes first.

    If the jamb (framing) is out of square, trim the top or bottom of the door where it binds, again shaving just a bit at a time. Adjust the striker plate as needed.

    If the latch is still misaligned with the striker plate, find out how much. Rub a lumber crayon on the plate and close the door; the latch bolt will scrape off the crayon mark, indicating how close it comes to the hole. If the alignment is off by more than 1⁄16″, shift the location of the plate: Remove it and reposition it on the jamb so that the hole surrounds the bolt location. Scribe around the outside of the plate with a sharp knife, then around the inside of the hole with a pencil. Chisel out the bolt hole. Screw the striker plate in perfectly flush, then make sure the latch bolt sinks easily into the striker plate hole when the door is closed.




    Get your FREE Trial Issue of Old House Journal and 2 FREE gifts.
    Yes! Please send me a FREE trial issue of Old House Journal and 2 FREE gifts.
    If I like it and decide to continue, I'll get 7 more issues (8 in all) for just $24.95, a savings of 48%. If for any reason I decide not to continue,
    I'll write cancel on the invoice and owe nothing. The Free Trial Issue is mine to keep, no matter what.
     
     Full Name:
     Address 1:
     Address 2:
     City:
     State:
     Zip Code:
     Email (req):
     
    Offer valid in US only.
    Click here for Canada or here for international subscriptions

    Products & ServicesHouse ToursHistoric PlacesHouse StylesOldHouseOnline.comMagazine
    Architectual ElementsKitchen & BathsHistoric HotelsArchitectural TermsRepairs & How ToSubscribe to Old-House Journal
    BathsInterior & DécorHistoric NeighborhoodsAmerican FoursquareFree NewslettersBack Issues
    Ceilings & WallsGardens & ExteriorsHouse MuseumsBungalowSubscribe to Arts & Crafts HomesDigital Editions
    Doors & WindowsColonial RevivalOld House CommunityAdvertise
    Exterior Products & LandscapeGothicAbout Us 
    FlooringQueen AnneContact Us 
    FurnitureVictorianPrivacy Policy
    HardwareLand for Sale
    Heating & CoolingSite Map
    Home Décor
    Kitchens
    Period Lighting
    Real Estate
    Repair & Restoration
    Roofing & Siding
    Tools & Equipment

    EXPLORE OUR HOME GROUP BRANDS:
     
    Designer Sourcw e bookHistoric Home Show Logo

    Copyright © 2011-2017 Old House Online